Setup Instructions:

# When installing MATLAB, if not already installed:
- Make sure to select the following toolboxes to install during installation when prompted (Click and go to support folder in DCS-301, look at pic titled '1','2','3' for reference):
	- Statistics and Machine Learning Toolbar
	- Curve Fitting Toolbox
	- Symbolic Math Toolbox

# Install the FT-232 Driver provided in disk with instrument:
	- Click on DCS-301 in the disk provided
	- Click on FT-232 icon in the folder that opens up
	- Click on CDM20600 icon. This will start and install the required driver software in your computer.

# Installing Techno_DCS toolbox for MATLAB:
- Open installed version of MATLAB
- Click 'Home' in the MATLAB toolbar (Look at picture titled '4' in support folder for reference).
- Click 'Open' in the Home toolbar that opens up after previous step (Look at picture titled '5' in support folder for reference).
- When prompted to browse, navigate to 'Techno_TCS' toolbox file provided in the disk with instrument.
  Exact path in the disk is: \DCS-301\MATLAB Toolbox (Look at picture titled '6' in support folder for reference).
- Click 'Open' to open the file. This will automatically add required toolbox into MATLAB.
- To verify successfuly installation: 
	- Go to 'Add Ons' in 'Home' toolbar of MATLAB. (Look at picture titled '7' in support folder for reference).
	- Click 'Manage Add Ons' (Look at picture titled '7' in support folder for reference).
	- Techno_TCS should be one of the installed toolboxes in the window that opens up. (Look at picture titled '8' in support folder for reference). 

# If the required toolboxes were not installed at the time of MATLAB installation. Follow the steps to install required toolboxes:
- Click on 'Add Ons' in 'Home' toolbar of MATLAB (ref. Picture titled '7 in support folder).
- Click 'Get Add Ons'  in the pop-up (ref. Picture titled '9' in support folder)
- Type in the name of following toolboxes one after the other and click install for each: (ref. Picture titled '10 in support folder).
	- Statistics and Machine Learning Toolbar
	- Curve Fitting Toolbox
	- Symbolic Math Toolbox

# Now toolbox is ready to perform the experiment.
- Before performing the experiment. Click on 'Add Ons' in the 'Home' toolbar of MATLAB (ref Picture '7' in support)
- Click on 'Manage Toolboxes' in the popup window
- Click on the 3 dots on extreme right of 'Techno_DCS' toolbox icon. A popup will come up. (ref. Picture '11' in support)
- Click 'Open Folder'

For any assistance contact below address:

Techno Instruments Pvt. Ltd.,
261/16, Civil Lines, Roorkee-247 667, U.K. (INDIA)
Phone : +91-1332-272852, 277118, Fax: 277118,
Email: info@sestechno.com, www.sestechno.com